PASSWORD PAGE CHANGE

Clingpeach · May 2010

Did the page change
In setup pressing protected setup is now bringing up a keyboard and then typing in the DEFAULT password does not bring you into the protected setup pages.
Is this new or is there something wrong with my NXD CV7

DHawthorne · May 2010

Just to be clear, the default password is 1988. It hasn't changed; it's entirely possible, though, that it got changed on yours somehow by mistake.

If you can make a telnet connection to your main AMX, you can reset it. Once connected type:

send_command <panel>, '@RPP'

... then press enter. Replace <panel> with the address of your touch panel (usually 10001 if you have only one). That should set it back to 1988.

Clingpeach · May 2010

Yes I know thats the default password. Thanks so much for your prompt reply...

Clingpeach · May 2010

So of course i couldnt wait for my programmer to wake up and I did it myself...THANK YOU SO MUCH DAVE..

DHawthorne · May 2010

Clingpeach wrote: »

So of course i couldnt wait for my programmer to wake up and I did it myself...THANK YOU SO MUCH DAVE..

I wish I had a few customers more like you

. Your welcome.

PASSWORD PAGE CHANGE

Comments