Panasonic AJ-D455

Comments

• edgelitoc Junior Member

  December 2008

  has any one has the rs232 code

  0 · Share on FacebookShare on Twitter
• Chip Moody Junior Member

  December 2008

  Here's the protocol. I don't remember where I used this, but based on the protocol I probably didn't write a module - just sent commands and didn't play with whatever feedback might have been available...
  
  - Chip

  Panasonic AJ-D455 RS232.pdf 379.2K

  0 · Share on FacebookShare on Twitter
• edgelitoc Junior Member

  December 2008

  thank you so much...

  0 · Share on FacebookShare on Twitter
• edgelitoc Junior Member

  December 2008

  did you use all pins on RS232C port, the pin configuration on Amx Side includes 2,3,4,5,6,7,8 which DTR,DSR,RTS and CTS are inlcuded, Would it matter if im using only the conventional RXD,TXD,Grd,, VTR side has 25 pins,

  0 · Share on FacebookShare on Twitter
• edgelitoc Junior Member

  December 2008

  Is this the format of sending commands to VTR Panasonic AJ-D455
  
  Button_event [dvcpro,180] //Play Button
  {
  Push:
  {
  send_string dvcpro,"02h,OPL,03h"
  }
  }

  0 · Share on FacebookShare on Twitter
• jazzwyld Registered User

  December 2008

  I'd Try this
  
  I'd try this unless someone else knows better..
  
  
  Is this the format of sending commands to VTR Panasonic AJ-D455
  
  Button_event [dvcpro,180] //Play Button
  {
  Push:
  {
  send_string dvcpro,"$02,'OPL',$03"
  }
  }

  0 · Share on FacebookShare on Twitter
• edgelitoc Junior Member

  December 2008

  thanks, i will try this,,
  what is the pin configuration you used...from amx to DVCpro

  0 · Share on FacebookShare on Twitter
• Chip Moody Junior Member

  December 2008

  As far as I can tell from the manual, you should only need 2, 3 & 5 from the AMX port, to 2, 3 and 7 on the deck, respectively. (The diagram in the manual completely contradicts the description above it - go figure) Worst case, you might have to swap 2 & 3 on one end of the cable.
  
  - Chip
  
  

  edgelitoc wrote: »

  did you use all pins on RS232C port, the pin configuration on Amx Side includes 2,3,4,5,6,7,8 which DTR,DSR,RTS and CTS are inlcuded, Would it matter if im using only the conventional RXD,TXD,Grd,, VTR side has 25 pins,

  0 · Share on FacebookShare on Twitter
• edgelitoc Junior Member

  December 2008

  just want to share this experience , The codes are working even if its from AJ-D450. I used only pins 2,3,5 from amx. After downloading the program. I got a response from DVC PRo $06$02ER001$03 which means unrecognized commands. I found the problem in Define call. Command should be directly place at button events.

  0 · Share on FacebookShare on Twitter