1st experience w/Mio Keypads

Kouya · December 2006

This is the first time I've worked with the Mio's
I'm adding some buttons to an exisiting installation how do you pull button channel programing from the devices. Also how do you send it.

I tried file tranfer and keep getting errors.

Thanks for any assistance

brian

fogled@mizzou · December 2006

In Keypad Builder, you've got to specify the IP of the controller (not the keypad itself) to send the files to. If that doesn't work, maybe more info would help: controller? connection mode (serial/IP)?

Kouya · December 2006

The controller is NI2000, and the keypads are connected via Axlink. I can see the keypad in the online tree when connecting IP. File tranfer timesout and fail when I try to pull the program files

fogled@mizzou · December 2006

Kouya wrote:

The controller is NI2000, and the keypads are connected vis Axlink.

Urk... I'm a bit of a Newbie myself; I was hoping I could contribute a simple answer to the forum, but I've never run those keypads off AxLink, so I don't have any other ideas for you. Sorry.

Colin · December 2006

Mio Keypads

Which model of Mio are you running?

Kouya · December 2006

They are Mio Classic-D panels

[Deleted User] · December 2006

Check the Device ID:

"I can see the keypad in the online tree when connecting IP. File tranfer timesout and fail when I try to pull the program files".

Make sure you have the correct device ID specified in the "Send Configuration Files" dialog of the KeypadBuilder application. You must specify a full device ID (ie. a D:P:S like 130:1:4561). If you see the keypad device in the online of NetLinx Studio, then you should be able to send the file down to the device via the KeypadBuilder application.

1st experience w/Mio Keypads

Comments

Categories