DVX-3255 Ethernet port config

feddx · January 2016

Silly question.

Is there any way to set the ethernet port on the DVX-3255 to manual 100/full instead of auto? I can't seem to find the command or the place on the web configuration to do so.

Thank you

vining · January 2016

Did you try telnet?

feddx · January 2016

vining wrote: »

Did you try telnet?

...and the telnet command to set the device to 100/full duplex are?

Odd they are not in the manual or the programming guide that I can see for the 3255. And on a general listing with the '?' query, I cannot see a command either.

Has this been eliminated with the NX processor?

I could just be missing it, but I'm not seeing it.

vining · January 2016

Don't know if they've been eliminated in the NX or not, just assumed they'd be there like NI. I'll take a look at mine when I return and see, haven't really spent much time going through their features to see what might be different.

vining · January 2016

Nope, don't see that option anymore in the NX controller.

PhreaK · February 2016

feddx wrote: »

...and the telnet command to set the device to 100/full duplex are?

set ethernet mode 100 full

If you're ever stuck for the commands from the telnet/SSH prompt just type `help`

vining · February 2016

PhreaK wrote: »
set ethernet mode 100 full
If you're ever stuck for the commands from the telnet/SSH prompt just type `help`

>set ethernet mode 100 full
Unknown Command 'set ethernet mode 100 full'
>

No joy on NX controllers, ? / help doesn't list anything similar to what the NI controller did for this option.

PhreaK · February 2016

Ah, completely missed the NX controller part.

GregG · February 2016

if you can force the switch port you are plugging into to 100/half, then autonegotiation on the amx side should fall back to match that.

https://en.wikipedia.org/wiki/Duplex_mismatch#Duplex_mismatch_due_to_autonegotiation

DVX-3255 Ethernet port config

Comments

Leave a Comment

Categories