DVX-3255 Ethernet port config

feddx

Silly question.

Is there any way to set the ethernet port on the DVX-3255 to manual 100/full instead of auto? I can't seem to find the command or the place on the web configuration to do so.

Thank you

vining

Did you try telnet?

feddx

vining wrote: »

Did you try telnet?

...and the telnet command to set the device to 100/full duplex are?

Odd they are not in the manual or the programming guide that I can see for the 3255. And on a general listing with the '?' query, I cannot see a command either.

Has this been eliminated with the NX processor?

I could just be missing it, but I'm not seeing it.

vining

Don't know if they've been eliminated in the NX or not, just assumed they'd be there like NI. I'll take a look at mine when I return and see, haven't really spent much time going through their features to see what might be different.

vining

Nope, don't see that option anymore in the NX controller.

PhreaK

feddx wrote: »

...and the telnet command to set the device to 100/full duplex are?

set ethernet mode 100 full

If you're ever stuck for the commands from the telnet/SSH prompt just type `help`

vining

PhreaK wrote: »

set ethernet mode 100 full

If you're ever stuck for the commands from the telnet/SSH prompt just type `help`

>set ethernet mode 100 full
Unknown Command 'set ethernet mode 100 full'
>

No joy on NX controllers, ? / help doesn't list anything similar to what the NI controller did for this option.

PhreaK

Ah, completely missed the NX controller part.

GregG

if you can force the switch port you are plugging into to 100/half, then autonegotiation on the amx side should fall back to match that.

https://en.wikipedia.org/wiki/Duplex_mismatch#Duplex_mismatch_due_to_autonegotiation