Promethean PRM-35/EST-P1

kennethk

Hi,

Any one successfully controlled a PRM-35/EST-P1 projektor from Promethean?

They have used to have have Sanyo projs. inside, but they seem to have changed OEM provider...

The codes are now:

Power ON:~PN<CR>
Power OFF:~PF<CR>
Input RGB:~SR<CR>
And so on...

I haven't managed to get it up and running yet...

Anyone familiar with either the model or have seen theese codes before??

Kenneth

ericmedley

kennethk wrote: »

Hi,

Any one successfully controlled a PRM-35/EST-P1 projektor from Promethean?

They have used to have have Sanyo projs. inside, but they seem to have changed OEM provider...

The codes are now:

Power ON:~PN<CR>
Power OFF:~PF<CR>
Input RGB:~SR<CR>
And so on...

I haven't managed to get it up and running yet...

Anyone familiar with either the model or have seen theese codes before??

Kenneth

Those codes are pretty straight-forward. Post your code. Perhaps there's a problem there.

kennethk

Thanks, but the problem is either faulty port on the projector,
or this document lies(attached).
Actually the document is only "named" PRM-35/EST-P1, so i actually don`t know wich model it is intended for.

Anyway.
Tried the codes out on a EST model(which should use the same protocol as the PRM-35), and it worked fine.

So the PRM-35, wich is out with the customer needs to be swaped(or i need to find the correct codes...)...?

Kenneth

Jimweir192

Did you try firing Sanyo cmd at it??

kennethk

Yes.
Didn't work


Kenneth