MVP8400i Front Button Access Disabled

westmo

Is there anyway to re-enable the Front Button Access option. To get back to the Config screens.

a_riot42

westmo wrote: »

Is there anyway to re-enable the Front Button Access option. To get back to the Config screens.

Send it the setup command from NS2.

John Gonzales

Or you can also send the 'setup' command using telnet.

--John

yuri

Or reboot the touchpanel and touch the center of the touchscreen while booting.

jjames

I prefer sending it back to AMX for repair.

yuri

jjames wrote: »

I prefer sending it back to AMX for repair.

have done that once
got a nice repair note back that said: "enabled front button setup access"

jjames

yuri wrote: »

have done that once
got a nice repair note back that said: "enabled front button setup access"

Ouch! They charge you for that?

ericmedley

While we're at it...

If you hold your finger in the center of the screen for six seconds during bootup, you'll be taken to the setup page. (as was stated earlier in the thread)

and...

If you continue to hold it there for another 6 seconds, you'll be taken to the calibtration page. handy for those panels that have wack calibrations....

HARMAN_rgelling

Setup

Telnet to the panel and type "setup". It will get you into the setup pages.
I don't know where the 6 seconds comes from when booting. That is not accurate. You have to be touching the display when the application starts. This is well into the boot process. The best bet is to simply touch the display when you apply power and continue touching until you end up at the setup pages. This can take up to 30 seconds.

yuri

jjames wrote: »

Ouch! They charge you for that?

off course

Another thing:
I like the way the new NX-500i panel works, holding the button enables setup menu, continue holding it enables calibration, continue holding it shuts down the panel