Home› DigiTech Forum› GNX Forum Achive› GENERAL› General Discussion and Chatter

New Powerpacks: The endless obsession

cfsguitarcfsguitar
in General Discussion and Chatter
Hey guys
Haven't been here in a lil while.
How's it goin? 8)

So the connection on my power supply seems to be actin up and I need a new one so can I Just go out and buy a new one or do I need to order it from digitech?

Thanks for the help

PEACE 8)
· Share on FacebookShare on Twitter

Comments

  • shreddshredd
    Jes' fix it. New connector. If it's a problem at the cube, g has some good methods.
    · Share on FacebookShare on Twitter
  • cfsguitarcfsguitar
    Show me these methods o wise one
    · Share on FacebookShare on Twitter
  • shreddshredd
    It's very easy. You just set me up with your wife's hott single friend, and then I come over and fix your p/s. 8)

    Either that, or you tell us which connection of your p/s is bad; if it's the plug end, it's easy to fix. If it's the end at the cube, you have to open it up and re-do it. g did a post once that details it.

    But I'd MUCH rather hook up with your wife's hott friend. :twisted:
    · Share on FacebookShare on Twitter
  • partchpartch
    Hey i fixed mine a while ago. mine was bad around the strain relief groment thingy. I took the cube apart along the seem scoring with an exacto knife then prying open with a flat blade. I then left the solder joints at the fuse & Tx-former alone I just cut the leads off the cord at a part of it past the damaged section restripped the wires tinned & soldered them back in place. I was sure to leave some strain releife so as the cord is pulled & moved around it does not focus on that weak part of the cord. I used lots of electrical tape to isolate the solder joints, also built up that area were the now spent groment was, and so it does not pull at the point were the groment was. Lastly I taped the housing back together around the seam & also taped the line cord feed side to the housing so it does not pul on the part the wires pass thru the housing. I mean hey it might not look the prettiest! BUT it took me 15min & cost me zero dollars with no down time! 8) I mean Hey I already had the soldering Iron,solder,exacto,ectrical tape, and flat blade srewdriver on hand. anyhow I know this isin't articulted the best! BUT I'm sure you can get the jist of what you need to do & look for when you get things opend? Be sure to check the fuse while your in there as well! :wink:
    · Share on FacebookShare on Twitter
  • shreddshredd
    Yuh, that's the procedure I was talking about...IF the problem is at the cube...

    So can I still meet your wife's hott friend?? :D
    · Share on FacebookShare on Twitter
  • cfsguitarcfsguitar
    Thanks for the help partch exactly what I needed.

    Sorry Shredd I don't have a wife, a lil to young for that, so no wife's hott friend, but if you can get scarlett to break up with van wilder I'm sure I can find someone who can fix your powerpack. :twisted:

    Anyway thanks for the help
    · Share on FacebookShare on Twitter
Sign In or Register to comment.