Gain Structure
I was reading an article about Gain Structure and it mentioned setting a gain level for Active Crossovers also. First it mentions this during the process "If your system uses active crossovers, for the moment, set all the crossover output level controls to maximum."
Then it goes on to mention an entire section for setting up "Active Crossover Output Level Controls" here http://www.rane.com/note135.html
I notice this is not mentioned in the Gain Structure sticky posted here, is this something a DRPA user should be concerened with??
Then it goes on to mention an entire section for setting up "Active Crossover Output Level Controls" here http://www.rane.com/note135.html
I notice this is not mentioned in the Gain Structure sticky posted here, is this something a DRPA user should be concerened with??
Comments
A "start" point at "Unity" would be appropriate for all devices. Unity is typically marked, either by a "0" or a detent, or both.
The standard custom set-up in a Driverack will default to -0- as a starting point.
DRA
Mixwiz2 does also.
The manuals to discribe how they are used are available for download at the A&H site. The MZ2 is under the Older products.
DRA