QSC K12's
Previously I had Mackie SRM 450's for FOH and a single Mackie SWA 1501 Sub. I have recently purchased QSC K12's for FOH and will not be using the Sub. I had run the crossover for my previous setup, and I am now wondering how to remove it from the mix. Are you able to turn off the crossover in the DRPA+, or is there a way to set it to full range?
Comments
Make another preset. (easy enough)
Lower the Low Pass Filter on the Hi output done to where you want it. (typically at or a bit below the -3 point on the speakers.
DRA