Routing and Configuration Assistance

JustBen · April 2011

Hello all,

I'm trying to configure my recently acquired Driverack 260 and I am not sure how to set the route how I desire.

Basically what I want is to run the 1 & 2 outputs for HF stereo, the 3 & 4 for MF stereo, then 5 as mono summed and 6 as mono summed so that I have different crossovers for the different sub woofers I'm running from 5 and 6.

Is this possible?

I have read through the manual and played around in the configuration area with unlinking 5 and 6 but I haven't figured out how to set them both to mono summed and have separate crossovers.

Cheers
Ben

Dra · April 2011

Are you using the Driveware GUI?

DRA

JustBen · April 2011

I have been using the front panel so far but planned on setting up Driveware tonight.

Dra · April 2011

It is way easy on the GUI. Have you downloaded the tutorial? It will guide you through how to do what you want.

DRA

JustBen · April 2011

No, I only read the users manual for the 260. I didn't realize there was a tutorial for Driveware..

I'll check it out!

Thanks.

Dra · April 2011

Look in the training tab above.

DRA

Routing and Configuration Assistance

Comments