DR260 + ITECH8000
Hi All,
I just hook up my DR 260 to an ITECH8000 amp I've purchased (driving a couple of SRX 728s cabinets).
I went through the wizard and it suggested all the default settings on the ITECH8000; okay, so far so good. However, at the end of the Wizard, when it would normally tell me to set the volume knob on some other amp to some value like 57%, there is.... nothing. Should I be setting the gain on the amp to 0dB or some other value? Not sure what should be done here.
Thanks,
Randy Hyde
I just hook up my DR 260 to an ITECH8000 amp I've purchased (driving a couple of SRX 728s cabinets).
I went through the wizard and it suggested all the default settings on the ITECH8000; okay, so far so good. However, at the end of the Wizard, when it would normally tell me to set the volume knob on some other amp to some value like 57%, there is.... nothing. Should I be setting the gain on the amp to 0dB or some other value? Not sure what should be done here.
Thanks,
Randy Hyde
Comments
DRA
Thanks,
Randy Hyde