DRPA on main inserts
:?: I'm new to forum but been using a DR for some years.
I usually use it In-line with the desk main outputs but before active pa. Just tried using it on Mackie Onyx main inserts. These are Pre fader so Driverack still getting signal with fader at Zero. - While I don't think this is a major problem, I did notice that setting AFS was innacurate as fixed filters were locked in due to constant signal.
Anyone know a work around or should I go back to In-line configuration.
Cheers
Shakes
I usually use it In-line with the desk main outputs but before active pa. Just tried using it on Mackie Onyx main inserts. These are Pre fader so Driverack still getting signal with fader at Zero. - While I don't think this is a major problem, I did notice that setting AFS was innacurate as fixed filters were locked in due to constant signal.
Anyone know a work around or should I go back to In-line configuration.
Cheers
Shakes
Comments
Gadget
There are no practical reasons for the change in configuration... just thought I'd give it a try
Gather by your response that In-line is preferred method of connection?
G