Macbook pro fusion windows 7 cannot connect

grunter375 · April 2010

Ok well as best i can see my new macbook running windws 7 under fusion on the LAN cannot connect to a 641m. I have set up the IP on the zone pro to 192.168.0.50 on my old laptop via RS-232 i can see the zone pro in both windows and snow leapord via ip scanner with 20ms ping times yet the software does not see it any ideas on this would be great.

mikejoeydbx · April 2010

Hi grunter375,

Have you tried setting your network card to "Bridged" instead of NAT, within VMWare fusion? Also, try turning off your wi-fi card to see if this helps.

grunter375 · April 2010

well thanks for the tip worked sort of i saw the zonepro once in the Designer window but now i cant, i can however see it in the network wizard but it only has "detected next to it"?

grunter375 · April 2010

ok got it all going need to change the network adaptor ti static so as it is on the same subnet as the zonepro all good thanks for the tip

Macbook pro fusion windows 7 cannot connect

Comments