MVP 8400 setup prolem

rsahmarani · February 2012

hello Gents,

during the upload of TP interface suddenly the transfer stop after arround 10 % .

now i coudn't enter to the setup mode even i could see the touch panel from the processor.

could anyone know what could be the solution ? ? ?

thanks

DHawthorne · February 2012

Most likely, you hit a bad spot on the CF card and it will need to be replaced. If you have an image of a good card of the same firmware revision, you could replace it yourself, but depending on your dealer status, it might be easier to to send it to AMX.

MVP 8400 setup prolem

Comments

Categories