CA10 Inverted
dszic
Junior Member
Anyone ever see a panel flip it graphics and setup pages? Tried panel reload and firmware...nada.
Comments
-
Duct Tape was invented for this very problem.
-
I vaguely remember there being a jumper or dip switch on the older passive wall-mount panels to invert the display, although I'm not sure if the active panels had that or not.
--D -
Is it a setting in the panel file itself set within TPD3? that seems to ring a bell for some reason...
-
While we're on the subject of G3 panels... (CV10s)
I still use lots of them in my personal residence and they still work great! they never go offline (even a wireless one.) -
Have a look at TechNote 559.
--D -
Although it sounds like it doesn't match your circumstances, we've seen this happen spontaneously with CV/CA/CG10. Only after the panel has been offline, unpowered for a while.
The image will be inverted, but the buttons are in the upright (original) positions on the touch surface.
A reload of the panel project seems to correct it when it does it this way... apparently not yours.
We've never seen this happen spontaneously on a panel that stays powered or is off only breifly. We suspect it is aged batteries. -
Crack it open and turn the LCD panel. Maybe this was done on purpose?
-
Of course that technote specifically states that the jumper to invert the image is ONLY on wall and rack mount panels, not on table top units like the original poster shows in his picture.Have a look at TechNote 559.--D -
If you ever opened one of these, you would know this is impossible. The LCD mounts only one way for cable routing.Crack it open and turn the LCD panel. Maybe this was done on purpose? -
Of course that technote specifically states that the jumper to invert the image is ONLY on wall and rack mount panels, not on table top units like the original poster shows in his picture.
I'm pretty sure the only real difference is the chassis. Though that doesn't mean it will be easy to open up and check.
Categories
- All Categories
- 2.5K AMX General Discussion
- 922 AMX Technical Discussion
- 514 AMX Hardware
- 502 AMX Control Products
- 3 AMX Video Distribution Products
- 9 AMX Networked AV (SVSI) Products
- AMX Workspace & Collaboration Products
- 3.4K AMX Software
- 151 AMX Resource Management Suite Software
- 386 AMX Design Tools
- 2.4K NetLinx Studio
- 135 Duet/Cafe Duet
- 248 NetLinx Modules & Duet Modules
- 57 AMX RPM Forum
- 228 MODPEDIA - The Public Repository of Modules for Everyone
- 943 AMX Specialty Forums
- 2.6K AMXForums Archive
- 2.6K AMXForums Archive Threads
- 1.5K AMX Hardware
- 432 AMX Applications and Solutions
- 249 Residential Forum
- 182 Tips and Tricks
- 146 AMX Website/Forums