Connection to Virtual Netlinx Master Lost

Comments

• DHawthorne Junior Member

  April 2010

  I've noticed that with new R4's, you need to wipe the existing pages from setup before you load a new file. I'm pretty sure that's the message you get if you don't. I think they pushed the factory pages in a write-protected mode.

  0 · Share on FacebookShare on Twitter
• rhargrave AMX Engineering

  April 2010

  What version of TPD4 and R4 firmware are you using? That sounds like a problem on the TPD4 side, but you never know.

  0 · Share on FacebookShare on Twitter
• glr-fti Junior Member

  April 2010

  I'm at 2.11 Build 619 and have noticed the same thing Dave describes....delete the user pages and then it works.

  0 · Share on FacebookShare on Twitter
• rhargrave AMX Engineering

  April 2010

  Are these brand new R4s or R4 that were upgraded to ZigBee Pro?

  0 · Share on FacebookShare on Twitter
• glr-fti Junior Member

  April 2010

  One was an upgrade, one was new.

  0 · Share on FacebookShare on Twitter