TP4 Copy And Past Popups

xrmichael · January 2010

Is there a way to select more than 1 popup or page at a time, i want to copy a load of popups for one design and drop them into another panel design, holding shift or ctrl does not have any effect.

Michael

Joe Hebert · January 2010

xrmichael wrote: »

Is there a way to select more than 1 popup or page at a timel

No, not that I'm aware of.

xrmichael · January 2010

Clicking

A lot of mouse clicks needed then, would it be a good addition to TP4. Or is it just me, it normally is.

vining · January 2010

xrmichael wrote:

would it be a good addition to TP4. Or is it just me, it normally is.

Nope, you're not alone it's been requested on the forum 352 times. Ok I made that number up, but alot of times.

ericmedley · January 2010

vining wrote: »

xrmichael wrote:

Nope, you're not alone it's been requested on the forum 352 times. Ok I made that number up, but alot of times.

bump - and some stuff to make this long enough

ericmedley · January 2010

bump - and some stuff to make this long enough

ericmedley · January 2010

vining wrote: »

xrmichael wrote:

Nope, you're not alone it's been requested on the forum 352 times. Ok I made that number up, but alot of times.

and again i say...

bump

DHawthorne · January 2010

I reiterate my call to make a panel merge feature. Then I can have a fully developed panel file for a specific device, and merge it in one operation to my project file. Give it an option to change port numbers as it merges, and it will save me hours on every project that switches from an Escient to a ReQuest, or anything of that nature.

Jorde_V · January 2010

I would also like this merge function. It would save me a lot of time if I could design device specific pages and simply merge them into my current project.

TP4 Copy And Past Popups

Comments

Categories