Factory Defaulting TPI/4

Comments

• vining X Member

  April 2009

  I think only the factory can do that.

  0 · Share on FacebookShare on Twitter
• shr00m-dew Junior Member

  April 2009

  Does the master code from G3 panels work on G4's?
  
  Kevin D.

  0 · Share on FacebookShare on Twitter
• TurnipTruck Junior Member

  April 2009

  I don't remember the G3 master codes. Any ideas?

  0 · Share on FacebookShare on Twitter
• shr00m-dew Junior Member

  April 2009

  Can't find where I wrote it down right now..
  
  I did find this:
  
  SEND_COMMAND dvTP,'^PWD-5,1988' Panel will need to be online.
  
  Edit: Found it... 1205. Some say its works on G4, others don't.
  
  Kevin D.

  0 · Share on FacebookShare on Twitter
• Marc Scheibein Junior Member

  April 2009

  1205 will NOT work in G4 panels.

  0 · Share on FacebookShare on Twitter
• TurnipTruck Junior Member

  April 2009

  Well, that was easy.
  
  Pressing the touch driver button on the front of the TPI4 got me into protected setup without a password. I was then able to change comm settings to match my system. I sent the PWD command and I'm good to go.
  
  Thanks.

  0 · Share on FacebookShare on Twitter