IR receiver on AXD-CP4/A

kru
kru Junior Member
in AMX Control Products
Hi everyone!

How IR receiver works on G3 panels? I have read documentation and try do it with AXD-CP4/A and third party remote with AMX codes(38 KHz) but it don't work :(.
· Share on FacebookShare on Twitter

Comments

  • TurnipTruck
    TurnipTruck Junior Member
    How are you expecting it to work?

    How would you know that it was working?
    · Share on FacebookShare on Twitter
  • ericmedley
    ericmedley Senior Member - 3709 Posts
    kru wrote: »
    Hi everyone!

    How IR receiver works on G3 panels? I have read documentation and try do it with AXD-CP4/A and third party remote with AMX codes(38 KHz) but it don't work :(.

    Some questions...

    Do you have the IR receiver device turned on?

    How many Devices are turned on in the panel?

    If you've set up the panel at base device 128 and have turned on the device number to 4 there will be four devices on the online tree. 128, 129, 130, 131. Then, if you have the IR receiver tunred on it should be showing up on the tree as device 132.

    If all of this is setup right, you would use Button_Events in your code.

    example
    DEFINE_DEVICE

dv_CP4A_IR_Rec  = 132:01:0

DEFINE_EVENT

BUTTON_EVENT[dv_CP4A_IR_Rec,nIR_Rec_Buttons]
{
push:
  {
  // when IR remote pushed, do something.
  }
}
    · Share on FacebookShare on Twitter
  • kru
    kru Junior Member
    well, i sep up a device base number to 140 and device used to 4. I see 4 devices in online tree, but there is no device number with 144. The button "Infrared push" is turned on and IR codes device is set to 5.
    · Share on FacebookShare on Twitter
  • DHawthorne
    DHawthorne Junior Member
    kru wrote: »
    well, i sep up a device base number to 140 and device used to 4. I see 4 devices in online tree, but there is no device number with 144. The button "Infrared push" is turned on and IR codes device is set to 5.

    That part 's correct. 140, 141, 142, 143 = 4 devices. But there is no device 5 ... where did that come from? Is that how they notate the IR transmitter?
    · Share on FacebookShare on Twitter
  • kru
    kru Junior Member
    DHawthorne wrote: »
    But there is no device 5 ... where did that come from?

    From manual:
    IR CODES DEVICE # allows a user to enable/disable the IR feature. This toggles the selection such that activating the button enables the IR Codes Device feature and de-activating ("reverse video") disables the IR Codes Device feature. The device number (n) displayed on the IR Codes Device button is one greater than the number shown on the device used button on the protected setup page...

    So, when i press this button it can be 0 or 5.
    · Share on FacebookShare on Twitter

Categories