5200i - slow transfer!

Comments

• DHawthorne Junior Member

  October 2008

  Seemed the same to me as an 8400 last one I did.

  0 · Share on FacebookShare on Twitter
• Joe Hebert Junior Member

  October 2008

  Transfers are fine with my 5200i also.

  0 · Share on FacebookShare on Twitter
• ericmedley Senior Member - 3709 Posts

  October 2008

  jjames wrote: »

  What's up with the SUUUUUPER SLOOOOOOW transfer? My gosh!!! Transferring our files to the 8400 is slow enough, and now make it even slower is making my transferring experiences horrendous!
  
  Anyone else noticing this?

  
  the two I've done are just fine...
  
  
  hmmmm...

  0 · Share on FacebookShare on Twitter
• jjames AMX Sustaining Engineer

  October 2008

  Must be the network . . . because we're now having some other issues.
  
  But even the one on my desk here seems to transfer slower than the 8400 I have sitting next to it.
  
  I'll have to run some tests later and see if it's a figment of my imagination or not.

  0 · Share on FacebookShare on Twitter
• a_riot42 AMX Wizard

  October 2008

  No issues here either. I am annoyed that you can't preview 5200s but that's another thread.
  Paul

  0 · Share on FacebookShare on Twitter
• Adam Gershon Moderator

  October 2008

  5200i Preview
  
  You can panel preview a 5200i, but you need to open the file directly with G4 Panel Preview, and not through TPD4. (and hence, need to close the file in TPD4, but you can do it)
  
  Adam

  0 · Share on FacebookShare on Twitter
• Spire_Jeff Formerly Caffeinated Programmer

  October 2008

  jjames wrote: »

  Must be the network . . . because we're now having some other issues.
  
  But even the one on my desk here seems to transfer slower than the 8400 I have sitting next to it.
  
  I'll have to run some tests later and see if it's a figment of my imagination or not.

  
  I have noticed that the wireless range on the 5200 is definitely less than the 8400 (newer 8400s). Maybe the 5200 is running at 2Mbps and the 8400 is running at 18Mbps ... or something like that?
  
  Jeff

  0 · Share on FacebookShare on Twitter
• a_riot42 AMX Wizard

  October 2008

  Adam Gershon wrote: »

  You can panel preview a 5200i, but you need to open the file directly with G4 Panel Preview, and not through TPD4. (and hence, need to close the file in TPD4, but you can do it)
  
  Adam

  
  Thanks Adam I will check that out.
  Paul

  0 · Share on FacebookShare on Twitter