Change a button state

Comments

• Jimweir192 Junior Member

  December 2007

  Post the code your trying to use...

  0 · Share on FacebookShare on Twitter
• cristibad Junior Member

  December 2007

  it's something like this:
  
  send_command dvtp1_test,"'^ANI-1,1,1,0'"
  
  it should change the state of the button with adress1 in mage test to 1...

  0 · Share on FacebookShare on Twitter
• cristibad Junior Member

  December 2007

  I found something like on[dvtp_test,1] and off and it's working.
  But now i want to verify let's say 10 variables value and depending on their values(1 or 0) to atomaticaly change the buttons states continouslly(the variables values can also be changed from another third party device).
  Thank you!

  0 · Share on FacebookShare on Twitter
• vining X Member

  December 2007

  It's easier to use a multi-state bar graph w/ 10 states and use send_levels with the variable equalling the desired state. So if the variable equals 1 it will display state 1. Make sure level range equals the number of state. 10 states level range = 1-10.

  0 · Share on FacebookShare on Twitter
• cristibad Junior Member

  December 2007

  now another problem is there any command like..."mod" or "div"

  0 · Share on FacebookShare on Twitter
• Danny Campbell Senior Member

  December 2007

  Are you refering to Modulo? If so you and use either MOD or % to get the remainder after division.

  0 · Share on FacebookShare on Twitter