Pool Controler?

parabola
parabola Junior Member
in AMX General Discussion
Does anyone have any luck with pool controllers? The only one I have used is a Jandy and that was years ago. I have read that Jandy may have improved slightly but im still nervous about recommending it to my dealer. Any suggestions would be great, thanks,
· Share on FacebookShare on Twitter

Comments

  • DHawthorne
    DHawthorne Junior Member
    I've used Jandy in the past, but, like you, it's been a while. They definitely were flaky ... worked, but needed constant resetting.

    I have a current job where I am integrating with a Pentair, but it probably won't go live until Spring. It looks to me to be nearly identical to the Jandy in function, and there is a module for it. How it works I can't yet say.
    · Share on FacebookShare on Twitter
  • Spire_Jeff
    Spire_Jeff Formerly Caffeinated Programmer
    I have dealt with Jandy in a couple of recent jobs (Spec'd by the pool people, not me) and they seem to be better than a few years ago. I just finished a job last week that has a Jandy controller. So far, it has been doing well. It installed without problems, but only time will tell if the interface will be reliable.

    One thing that I have learned is to always move the serial adapter next to your processor and out of the equipment room that houses the Jandy processor.

    Jeff
    · Share on FacebookShare on Twitter
  • glr-fti
    glr-fti Junior Member
    I've used Compool with Landmark and now the replacement Intellitouch with Netlinx without any problems except that the pool contractor is a jerk. Pentair is the manufacturer.
    · Share on FacebookShare on Twitter

Categories