Newbie code question help please!

KeithJust · October 2007

Hi guys.

Wondered if anyone could help me with an efficient way of doing this?

PLH-VS8

If output X is turned on

Then turn on input X,X and output X,X

If output X is turned off

Then turn turn off input X,X and output X,X

Any help would be greatly appreciated!

TonyAngelo · October 2007

A channel event should would work

CHANNEL_EVENT[dvDEV,1]
{
     ON:
     {
          // Turn on output X,X
     }
     OFF:
     {
          // Turn off output X,X
     }
}

KeithJust · October 2007

I am having a hard time knowing what channels to turn on and off. When I look at what is being sent and recieved from the switch it looks like a hex string. For example if video input #2 goes on and I want to then turn on video input #3 and #4 and also turn on video output # 3 and #4 how would I do that?

jazzwyld · October 2007

What type of switch are you talking about? Is this just an a/v switch? It sounds like you want to do matrix switching, if you can describe it a little more, someone may be able to help you.

KeithJust · October 2007

Thanks for the reply guys! The switch is a PLH-VS8 and is running under a DXP program which only uses composite video (which is ok for some zones but not for others). I was looking for a way I can get some of the zones to route component video. I thought a good way would be monitor the composite outputs and when a certain one is turned on to have a small additional piece of code turn on some inputs and outputs based on monitoring that composite output. Hope this makes some scense to you guys. Thanks again for your help!

sieb · October 2007

Yes there is. See my reply under Netlinx Studio...

Scott

Newbie code question help please!

Comments

Categories