INPUT led on Ni3000 light all the time

Comments

• Marc Scheibein Junior Member

  September 2007

  Maybe the operation mode of that I/O was reconfigured to "High active". Try the following command form terminal/telnet, or in the DATA_EVENT..ONLINE of the I/O device:
  SEND_COMMAND 5001:17:0,'SET INPUT 1 LOW'
  This would set Input 1 to LOW active (default setting), which means you have to pull it to ground to get a PUSH.

  0 · Share on FacebookShare on Twitter
• VladaPUB as it is !

  September 2007

  It is INPUT led near the OUTPUT led, not I/o port led ! I cant connect to master, i have tried trought Serial and IP but with no results.

  0 · Share on FacebookShare on Twitter
• Marc Scheibein Junior Member

  September 2007

  Ups, misunderstood.....

  0 · Share on FacebookShare on Twitter
• VladaPUB as it is !

  September 2007

  As I understand you over the phone, the problem is in firmware
  
  So , just to leave it as "solve", I can't do anything

  0 · Share on FacebookShare on Twitter
• DHawthorne Junior Member

  September 2007

  VladaPUB wrote:

  As I understand you over the phone, the problem is in firmware
  
  So , just to leave it as "solve", I can't do anything

  
  This is a classic symptom of a corrupted CF card. It's possible it could be something else, but that is the most likely. AMX did have a bad batch of them at one point, long since resolved, but there have got to be some of the bad ones still floating around waiting to die.

  0 · Share on FacebookShare on Twitter
• REBUILD_EVENT Junior Member

  September 2007

  I HAVe had this once, when I did COMBINE_DEVICE twice on the same devs.

  0 · Share on FacebookShare on Twitter