Beeping G3 Touchpanel

Spannertech
Spannertech Junior Member
in AMX Hardware
I know that intermittent beeps can mean not enough volts getting to the panel. AMX say they need 12.5v measured at the back of the panel. I have one (it is my personal one purchased off EBay and it has worked for years) that has recently started to do the beeps and is still beeping even with 13v on its input. Just wondering if it's the voltage regulator IC that goes - I could easily replace that myself. Any one been inside one of these?

Thanks

OP
· Share on FacebookShare on Twitter

Comments

  • Wazza
    Wazza Junior Member
    Hi Guys,
    Long time viewer, first time replier. I had the same intermittent beep problem a few weeks ago and it turned out to be clashing device ID's with an old RF reviever I had forgotten about attached further down the line. I had the same thoughts on power but in my case, I was wrong.

    Cheers
    Waz
    · Share on FacebookShare on Twitter
  • vincen
    vincen Junior Member
    Well it can be power that is too short or a conflict on bus between two devices, or also erratic issues on AXLink (lack of stability or bad wiring).

    Vinc
    · Share on FacebookShare on Twitter

Leave a Comment

BoldItalicStrikethroughOrdered listUnordered list
Format
SpoilerCodeQuote
Heading 2Heading 1
Emoji
:):D:(;):/:o:s:p:'(:|B):#:*<3o:)>:)
Url
Image
Align leftAlign centerAlign rightToggle HTML viewToggle full pageToggle lights
Drop image/file
Comment As ...

Categories