Keypad Builder Locks on install

Comments

• B_Clements Senior Member

  September 2005

  No problems with the install
  
  You have some type of font problem.

  0 · Share on FacebookShare on Twitter
• Joe Hebert Junior Member

  September 2005

  Kevin,
  
  Check out the bottom of this thread and see if it gets you any farther.
  
  http://www.amxforums.com/showthread.php?t=357
  
  Others have voiced the same type of concern with other AMX installs freezing when it gets to an AMX font. I've never had a problem but I'm not running any type of font manager program. If you are you may want to try turning it off and see if the install goes through.
  
  Good luck.

  0 · Share on FacebookShare on Twitter
• mkassal Junior Member

  October 2005

  Keypad Builder Install Workaround.
  
  Try Installing it in a different directory. Had the same problem, I did this after downloading it once more.
  
  Then It worked aok.
  
  The only thing that was a bummer, is you cannot print a picture of the keypad out. How can one show clients what they are going to get?
  
  This functionality is highly needed!

  0 · Share on FacebookShare on Twitter
• shr00m-dew Junior Member

  October 2005

  I ran a complete WebUpdate the other day, and keypad builder was one of the files it got. Installed fine running through Webupdate.. Go figure..
  
  Kevin D.

  0 · Share on FacebookShare on Twitter
• vincen Junior Member

  October 2005

  mkassal wrote:

  The only thing that was a bummer, is you cannot print a picture of the keypad out. How can one show clients what they are going to get?

  
  I think you are supposed to use online tools to get a sample of what you'll do in programmation later http://www.amx.com/keypad and there you can print result
  
  Vince

  0 · Share on FacebookShare on Twitter
• joeyjoejo1200 TP God

  October 2005

  On the keypad Preview / KeypadBuilder products . . .
  
  What other features would you like to see?

  0 · Share on FacebookShare on Twitter