Options
newbie to I/O - possibly a stupid question...
hodeyp
Junior Member
in AMX Hardware
I am usung an NI3000 controller and am looking to use the scart connector on my DSS box to monitor power and picture domension (4:3 or 16:9). Pin 8 on the scart connector is used a follows...
8 0-2.5 volts (low) when:
- digibox is in standby (or digibox is out of standby & 'Scart control' setting is "OFF')
- VCR is not in playback or onscreen graphics (OSG) mode
4.5-7.5 volts (High-to-6v) when:
- digibox is out of standby,
- 'scart control' setting is 'on',
- picture format setting is '16:9',
- digibox is outputting a 16:9 programme
or when:
- VCR is in playback or OSG mode
9-12 volts (high-to-12v) when:
- digibox is out of standby,
- scart control setting is on,
- picture format setting is '4:3' (or set to '16:9' but digibox is outputting a 4:3 programme)
Not ever using the I/O sensors before I am unsure as to how to do this, any advice would be very much appreciated...
Phil
8 0-2.5 volts (low) when:
- digibox is in standby (or digibox is out of standby & 'Scart control' setting is "OFF')
- VCR is not in playback or onscreen graphics (OSG) mode
4.5-7.5 volts (High-to-6v) when:
- digibox is out of standby,
- 'scart control' setting is 'on',
- picture format setting is '16:9',
- digibox is outputting a 16:9 programme
or when:
- VCR is in playback or OSG mode
9-12 volts (high-to-12v) when:
- digibox is out of standby,
- scart control setting is on,
- picture format setting is '4:3' (or set to '16:9' but digibox is outputting a 4:3 programme)
Not ever using the I/O sensors before I am unsure as to how to do this, any advice would be very much appreciated...
Phil
Comments
- Chip
Thanks,
Jeff