Netlinx ni3100 programming issues
Hi Guys,
My issue:
-Touch panel controls the ni3100. CAN see channels coming in (notification/diagnostic ON)
-The ni3100 sends strings to port/rs232/device (confirmed with telnet and Control device after capacitor repair job)
- Port is not sending strings from source code generated commands.
My issue:
-Touch panel controls the ni3100. CAN see channels coming in (notification/diagnostic ON)
-The ni3100 sends strings to port/rs232/device (confirmed with telnet and Control device after capacitor repair job)
- Port is not sending strings from source code generated commands.
Comments
-
If you were to remove code from the troubleshooting equation, are you able to send test strings successfully through Control a Device within Netlinx Studio?
-
I frequently use IP-RS232 devices like the MOXA boxes as a sanity check. They can easily be swapped in as a substitute for the controller's serial ports, and also be placed at the destination to confirm correct transmission & receipt of data.
-
All good now guys ! Forgot to reboot after messing with config dip switches
Categories
- All Categories
- 2.5K AMX General Discussion
- 922 AMX Technical Discussion
- 514 AMX Hardware
- 502 AMX Control Products
- 3 AMX Video Distribution Products
- 9 AMX Networked AV (SVSI) Products
- AMX Workspace & Collaboration Products
- 3.4K AMX Software
- 151 AMX Resource Management Suite Software
- 386 AMX Design Tools
- 2.4K NetLinx Studio
- 135 Duet/Cafe Duet
- 248 NetLinx Modules & Duet Modules
- 57 AMX RPM Forum
- 228 MODPEDIA - The Public Repository of Modules for Everyone
- 943 AMX Specialty Forums
- 2.6K AMXForums Archive
- 2.6K AMXForums Archive Threads
- 1.5K AMX Hardware
- 432 AMX Applications and Solutions
- 249 Residential Forum
- 182 Tips and Tricks
- 146 AMX Website/Forums