Options

Netlinx Studio 4.0 can't load Dxlink Rx box firmware successfully

leoncao Junior Member

December 2015 in NetLinx Studio

Hi all,

I wanted to upgrade new firmware for my Dxlink Rx Box, and I found that I use Netlinx Studio 4.0 to open "SW1010_500_AVB_KIT_DXLINK_RX_v1_9_53.kit",

but Netlinx Studio 4.0 can't load firmware file successfully, It jump a error message "Failed to load applcation, check installation"

Could you help me to work out this issue,please!

Thanks!

Leon

a2.jpg 47K

0 ·

Comments

MLaletas Junior Member

December 2015

Your device ID is set to 0. Set it to the device ID of the receiver

0 · Share on Facebook Share on Twitter
leoncao Junior Member

December 2015

Hello，

It has nothing to do with set device ID, because when I select the item for "SW1010_500_AVB_KIT_DXLINK_RX_v1_9_53.kit" , it would jump
error message window.

Thanks!

0 · Share on Facebook Share on Twitter
ericmedley Senior Member - 3709 Posts

December 2015

leoncao wrote: »

Hello，

It has nothing to do with set device ID, because when I select the item for "SW1010_500_AVB_KIT_DXLINK_RX_v1_9_53.kit" , it would jump
error message window.

Thanks!

Try setting the device ID prior to clicking on the software file name.

0 · Share on Facebook Share on Twitter

or Register to comment.