Panasonic PT-LW330 Projector Power commands

prakash Member

December 2014 in NetLinx Studio

Hi,

I am trying to control panasonic projector which is connected to DXLINK HDMI-RX (6004:1:2), where 2 is the DGX-16's system number.

When i am sending these commands:

send_string 6004:1:2,"$02,'PON',$03" //Power ON

send_string 6004:1:2,"$02,'POF',$03" //Power OFF

In FROM STRING of the device i am getting $E4,$E7 or G.

Not able to control the projector.. Does anyone tried any other commands? Do i need to change anything in the projectors menu using remote?

Thanks

0 ·

Comments

Hugh Barker@PV Junior Member

December 2014

Check that you have setup the correct baud rate. Sometimes the serial strings need a carriage return at the end of the string $0D.

0 · Share on Facebook Share on Twitter
mritz Junior Member

December 2014

I believe that you are using the wrong baud rate. The older panasonic projectors and as I know all professional models are using 9600,N,8,1. All the newer and consumer models are using 19200,N,8,1.

Here is what the manual says:

Regards,

Markus

pt_lb330_en.png 41.8K

0 · Share on Facebook Share on Twitter
prakash Member

December 2014

Thanks Markus.. Its working with 19200 baud.

0 · Share on Facebook Share on Twitter

Panasonic PT-LW330 Projector Power commands

Comments

Categories