Cisco DTA170HD

Jim Johnson
Jim Johnson Junior Member
in AMX Technical Discussion
My cable provider came and installed one of these at my house. I'm trying to find IR codes for it. there is a bit of buzz on the interwebs about these things, mostly how universal remotes don't work very well. I don't have an IRIS, and I can't find a good IR file for my NI-2000. so now I have a touch panel and have to change channels with the stupid remote. There is an external IR reciever jack, direct connection would be cool. Of course because this my personal system, the budget is $0

any help would be appreciated
...Jim...
· Share on FacebookShare on Twitter

Comments

  • tweekend
    tweekend Junior Member
    Have you found anything that works? We have the same model here that was just installed in the board room of a school district and I am striking out on finding an IR code that gives me control over the box for channel changing.

    Thanks in advance
    · Share on FacebookShare on Twitter
  • Jim Johnson
    Jim Johnson Junior Member
    Nope, I've dug around the interwebs and tried a few hex code sets i put into IRedit, But no luck.
    ...Jim...
    · Share on FacebookShare on Twitter
  • Kenny
    Kenny Junior Member
    Have you tried the Motorola DCT series of IR codes?
    I recently ran across a Cisco that was actually a Motorola.
    · Share on FacebookShare on Twitter
  • Jim Johnson
    Jim Johnson Junior Member
    Success!! It wasn't the Motorola that worked though. It was a scientific Atlanta Set top box file that did the trick. The file is: scient09.irl
    This seems to work with the flasher, I have not tried with the direct wire yet. I also haven't tried all the functions but the 0-9 work for channel changing.
    Apparently Cisco bought Sci Atl.
    now I can put the remote back in the drawer where it belongs!
    ...Jim...
    · Share on FacebookShare on Twitter

Categories