S4.8 manual, anyone?

Comments

• HARMAN_Chris Harman Professional University

  November 2013

  The install guide documentation is attached. Please let me know if this does not solve your problem.

  SSeriesInstallationGuide.zip 1.2M

  0 · Share on FacebookShare on Twitter
• gravityhammer Junior Member

  November 2013

  Thanks, Chris. It doesn't look like that manual lists the jumper settings. Is there perhaps a tuner module manual floating around somewhere?

  0 · Share on FacebookShare on Twitter
• HARMAN_Chris Harman Professional University

  November 2013

  I do not see anything specific to that model. Have you looked at the documentation on the Tango tuner to see if the jumper methodology looks similar to that on your S series board?
  
  http://www.amx.com//assets/manuals/DAS-AMFM.InstallationGuide.pdf
  
  Additionally, if you have access to Tech Support, call in and you will most likely be connected to the Cheney Washington team who has taken over tier 2 for Matrix Audio products.

  0 · Share on FacebookShare on Twitter
• gravityhammer Junior Member

  November 2013

  Yeah - it's not quite the same. I'll have to play around with it, I guess.

  0 · Share on FacebookShare on Twitter
• ericmedley Senior Member - 3709 Posts

  November 2013

  I seem to remember the jumpers on the card were actually labeled with human communication instead of the usual "J1" or "J2" or whatever.

  0 · Share on FacebookShare on Twitter
• gravityhammer Junior Member

  November 2013

  ericmedley wrote: »

  I seem to remember the jumpers on the card were actually labeled with human communication instead of the usual "J1" or "J2" or whatever.

  
  I don't remember seeing that, but I'll check again - thanks!

  0 · Share on FacebookShare on Twitter
• bano Senior Member

  November 2013

  gravityhammer wrote: »

  I don't remember seeing that, but I'll check again - thanks!

  
  Put all jumpers in the off position to use source 1 if no internal tuner is used.

  0 · Share on FacebookShare on Twitter
• gravityhammer Junior Member

  November 2013

  bano wrote: »

  Put all jumpers in the off position to use source 1 if no internal tuner is used.

  
  Thanks for the response.
  
  I have all of the jumpers removed on the piece in the picture attached. Still, I get very low gain through inputs 1 & 2 - almost like it's bleed-over. Is this the right piece?
  
  I have verified the input/output gains on these two inputs.

  IMG_20131118_190059.jpg 605.1K

  0 · Share on FacebookShare on Twitter
• gravityhammer Junior Member

  November 2013

  On further inspection, it appears to just be input #2 that isn't working, if that matters.

  0 · Share on FacebookShare on Twitter