What device do Enova video swiching SEND_COMMANDS go to?

Comments

• jdonachiue@shaw.ca Junior Member

  October 2013

  Have not used the Enova DVX yet, but with the Enova DGX you use:
  i.e.
  Send_Command 5001:2:1, "cmd";
  or
  Send_Command 5002:2:2, "cmd";
  Send BCS Commands to port 2 of the Enova DGX
  
  I am pretty sure it is the same for the DVX.

  0 · Share on FacebookShare on Twitter
• mpullin Obvious Troll Account, Marked for Deletion

  October 2013

  It took me a little while to figure it out, too. The device is 5002, the port should correspond to a valid output, e.g. routing video input 2 to output 3 would be:
  

  SEND_LEVEL 5002:3:1, 50, 2; // 50 is the level for video switching, 51 for audio switching
  //OR
  SEND_COMMAND 5002:3:1, "'CI',itoa(2),'O',itoa(3)"; // I am not sure it matters which port you send command to but in my program I send to the same port as the output and that works
  

  
  You'll get commands as feedback, on 5002:1:1, e.g.
  SWITCH-LVIDEOI2O3

  0 · Share on FacebookShare on Twitter
• travis Junior Member

  October 2013

  ah thanks
  for the level event too. i didn't notice that.
  kind of annoyed at this switching ports thing

  0 · Share on FacebookShare on Twitter
• GregG Just some guy...

  October 2013

  Also in the DVX compared to DGX sometimes you specify the switching layer by number and other times by name:
  
  Send_Command 5002:2:1,'CLVIDEOI2O3'
  
  compared to
  
  Send_Command 5002:2:1,'CL1I2O3'

  0 · Share on FacebookShare on Twitter
• annuello Junior Member

  November 2013

  And a heads-up: On the DVX-2100 you will want to queue your commands to the switcher. It won't cope with a heap of commands all at the one time. I queue mine and "release" them to the switcher at a 300 mSec interval for most commands. The exception is the VIDIN_FORMAT command which I put 3 seconds of "breathing room" on either side of sending the command.
  
  This issue does not apply to the DVX-2150/2155/3150/3155 series.
  
  Roger McLean
  Swinburne University

  0 · Share on FacebookShare on Twitter
• TUTech Junior Member

  August 2016

  Where is the programming information located? What is the name of the PDF? I have the same problem. I have to program an Enova that I don't have access to at this time.

  0 · Share on FacebookShare on Twitter
• HARMAN_Chris Harman Professional University

  August 2016

  From the DVX Product Info page:
  firmware 3.0: http://www.amx.com//assets/manuals/NetLinxControllers.WebConsole-ProgrammingGuide.FMv3.pdf
  firmware 4.0: http://www.amx.com//assets/manuals/NetLinxControllers.WebConsole-ProgrammingGuide.FMv4.pdf
  
  

  0 · Share on FacebookShare on Twitter